Power2 Amp

Power2 Amp

The Power2 adds onboard amplification to the broad coverage speaker, making a separate amplifier unnecessary. Designed specifically for applications where only a single wide dispersion speaker is required for coverage, the Power2 provides an easier and less expensive installation in such areas as small warehouses, open-ceiling classrooms or lecture halls with video projectors; board rooms; and small retail stores.

The amplifier has been designed to mount to the rear of the reflector. Two electronically balanced inputs with level controls are provided. The amplifier also includes a master output level control. Two electronically balanced inputs, Level control for each input, Master level control. This amp is compatible with the 110B and the Q-6.

Power Output at 4 Ohms: 30 Watts RMS
Input Impedance: 20K Ohms
THD+N 1kHz @ 30W RMS: ≤ 0.4%
Gain: 20dB
Input Sensitivity for 30W RMS Output: 1.0 VRMS
Protection: Speaker short, Speaker lead short to ground, Overcurrent, Thermal, Power supply polarity
Maximum SPL @ 30 WRMS: 103dB SPL @ 1m (Model Q-6)
Specifications: Power2 AmpMounting hardware included